How to accurately count the number of drill rods in the well site

Preparation

Before counting the number of drill rods in the well site, the following preparations must be done:

1. Accurately record the number of drill rods

The logger needs to accurately record the number of drill rods in the well site in advance, which can be done through the well site drill rod ledger or other recording methods.

2. Check the storage location of the drill rods

When counting the drill rods, it is necessary to check whether all the drill rods are stored in the designated location to ensure that they are not lost or mixed up.

3. Ensure that the relevant tools are ready

It is necessary to ensure that the relevant tools required for counting the drill rods in the well site are ready, such as counters, steel tape measures, etc.

Methods for counting the number of drill rods in the well site

1. Count by group

In the well site, the number of drill rods is very large. In order to facilitate counting, the drill rods can be allocated according to groups, and then count each group separately.

2. Use counters

You can use counters to count, and count each drill rod once. If it is found that the counter does not match the recorded number, you need to carefully check each drill rod to determine the reason.

3. Check the mark

Each drill pipe should be marked or numbered. When counting the number of drill pipes, check whether the mark of each drill pipe is clear and correct.

4. Check the joint

When counting the number of drill pipes, pay attention to whether the joints between each drill pipe are complete and normal. If there is a problem with the joint, it needs to be dealt with in time.

5. Measure the length

While counting the number of drill pipes, you can also measure the length of each drill pipe to see if it meets the regulations to determine whether it needs to be replaced.

Complete the inventory record

After counting the number of drill pipes in the well site, it is necessary to complete the record in time to ensure the accuracy of the recorded data and provide a basis for subsequent work.

Conclusion

Counting the number of drill pipes in the well site requires careful and careful operation. The use of reasonable methods and tools can effectively reduce the probability of errors. Mud loggers need to attach great importance to this work, constantly summarize and improve in the work, and ensure the normal operation of the well site.

Article source: https://article-realm.com/article/Business/65847-How-to-accurately-count-the-number-of-drill-rods-in-the-well-site.html