edit the type of model and manipulate all these features via the Frsky Receiver S8R

The S8R is a FrSky 8 and 16 channels receiver built-in 3-axis gyroscope and 3-axis accelerometer sensor module. For conventional Fixed Wing and Glider Models it will support stabilization, automatic level, hover and Knife-edge flight modes, for Delta Wings or flying wings and V-tail models it supports stabilization and automatic level flight modes. You can edit the type of model and manipulate all these features via the Frsky Receiver S8R. Config or S8R. lua. The Frsky Receiver S8R can also be used as a standard 8 channel X series receiver if it is required.

Tip: Use the S8R with 3-axis stabilization as a slave receiver with the RB-10 to give you that extra peace of mind by buying you precious time to bring your model home.

Frsky Receiver S8R Specification：

  Dimension: 46.47×26.78×14.12 mm (L×W×H)
  Weight: 14g
  Number of Channels: 8/16CH (1-8ch from conventional channel outputs, 1-16ch from SBUS output)
  With RSSI PWM output on board: PWM voltage output(0-3.3V), 100Hz, 1500±500us
  Operating Current: 120mA@5V
  Operating Voltage Range: 4.0-10V
  Operating Range: full range
  Gyroscope Measurement Range: ±2000dps
  Accelerometer Measurement Range: ±4g
  Firmware Upgradeable
  Compatibility: FrSky Taranis X9D Plus/X9E/X7/Horus X12S/XJT in D16 mode 
(PS: S8R-EU only works with FrSky Taranis X9D Plus/X9E/X7/Horus X12S/XJT in D16-EU mode)

Frsky Receiver S8R Features:

  Built-in 3-axis gyroscope and 3-axis accelerometer sensor module
  Built-in RSSI PWM output(0-3.3V)
  Built-in battery voltage detection
  Smart Port enabled
  SBUS Port enabled

Article source: https://article-realm.com/article/Health-Fitness/7155-edit-the-type-of-model-and-manipulate-all-these-features-via-the-Frsky-Receiver-S8R.html